Brocade Communications Systems StoreFabric SN6500B Reference page 307

Recommended
This is often a transient error.
Action
Watch for the EM-1048 message, which indicates that the problem has been resolved.
If the problem persists, check for loose or dirty connections. Remove all dust and debris before reseating
the field-replaceable unit (FRU). If it continues to fail, replace the FRU.
EM-1031
Message
<FRU Id> ejector not closed.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the environmental monitor (EM) has found a switch blade that is inserted, but at least one
ejector switch is not latched. The blade in the specified slot is treated as not inserted.
Recommended
Close the ejector switch (raise the slider in most blades or completely screw in the upper thumbscrew) if
Action the field-replaceable unit (FRU) is intended for use. Refer to the appropriate Hardware Reference
Manual for instructions on inserting the switch blades.
EM-1033
Message
CP in <FRU Id> set to faulty because CP ERROR asserted.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the standby control processor (CP) has been detected as faulty. The high availability (HA)
feature will not be available. This message occurs every time the other CP restarts, even as part of a
clean warm failover. In most situations, this message is followed by the EM-1047 message, and no
action is required for the standby CP; however, find the reason for failover.
Recommended
If the standby CP was restarted, wait for the error to clear (execute the slotShow command to determine
Action if it has cleared). Watch for the EM-1047 message to verify that this error has cleared.
If the standby CP continues to be faulty or if it was not intentionally restarted, check the error logs on the
other CP (using the errDump command) to determine the cause of the error state.
Reseat the field-replaceable unit (FRU). If the problem persists, replace the FRU.
EM-1034
Message
<FRU Id> set to faulty, rc=<return code>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the specified field-replaceable unit (FRU) has been marked as faulty for the specified
reason.
Fabric OS Message Reference
53-1002749-01
5
EM-1031
285