Brocade Communications Systems StoreFabric SN6500B Reference page 872

5
SWCH-1022
SWCH-1022
Message
Port:<port number> has been disabled due to port address conflict while enabling
FMS mode.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the switch has ports with FICON Management Server (FMS) reserved areas (0xFE, 0xFF)
that are not supported in FMS mode.
Recommended
No action required. Refer to the FICON Administrator's Guide for more information.
Action
SWCH-1023
Message
HA state out of sync: Standby CP (ver = <standby SWC version>) does not support
XISL use while fmsmode and/or lossless are enabled (Active CP version =<active SWC
version>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not support extended inter-switch link (XISL)
while FICON Management Server (FMS) mode and Lossless are enabled.
Recommended
Load a firmware version on standby CP that supports both XISL use and FMS mode and Lossless at the
Action same time by using the firmwareDownload command.
SWCH-1024
Message
HA state out of sync: Standby CP (ver = <standby SWC version>) does not support
active's enforce_login policy (Active CP version =<active SWC version>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not enforce login policy of the active CP.
Recommended
Configure the enforce login policy to a value that the standby CP supports.
Action
850
Fabric OS Message Reference
53-1002749-01