Brocade Communications Systems StoreFabric SN6500B Reference page 572

5
HIL-1107
HIL-1107
Message
Switch faulted, <nominal voltage> (<measured voltage>) above threshold. System
preparing for reset.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the switch voltage is above threshold. This message is specific to non-bladed switches.
Recommended
For switches that do not have field-replaceable units (FRUs), replace the entire switch.
Action
If the 12 volt level is faulty, replace one or both power supplies; if any other voltage is faulty, replace the
entire switch.
HIL-1108
Message
Switch faulted, <nominal voltage> (<measured voltage>) below threshold. System
preparing for reset.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the switch voltage is below threshold. This message is specific to non-bladed switches.
Recommended
For switches that do not have field-replaceable units (FRUs), replace the entire switch.
Action
If the 12 volt level is faulty, replace one or both power supplies; if any other voltage is faulty, replace the
entire switch.
HIL-1201
Message
Blower <blower number>, speed (<measured speed> RPM) above threshold.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the fan speed (in RPM) has risen above the maximum threshold. A high speed does not
necessarily mean that the fan is faulty.
Recommended
Run the tempShow command to verify that the switch temperatures are within operational ranges. Refer
Action to the hardware reference manual for the temperature range of your switch.
Make sure that the area is well-ventilated and that the room temperature is within the operational range
of your switch. Refer to the hardware reference manual for your switch for the operational temperature
range.
Run the fanShow command to monitor the speed of the fan generating this error.
If the fan continues to generate this message, replace the fan FRU.
550
Fabric OS Message Reference
53-1002749-01