Brocade Communications Systems StoreFabric SN6500B Reference page 873

SWCH-1025
Message
This Logical Switch has ports other than 16 Gbps-capable FC ports. Edge Hold Time
for these ports is unchanged and is <Edge Hold Time>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the edge hold time for the non 16 Gbps-capable FC ports is not the same as 16
Gbps-capable FC ports in the logical switch. The non 16 Gbps-capable FC ports use the edge hold time
configured on the default switch.
Recommended
To know the edge hold time configured for non 16 Gbps-capable FC ports, go to the default switch and
Action execute the configShow command.
SWCH-1026
Message
HA state out of sync: Standby CP (ver = <standby SWC version>) does not support
auto csctl_mode (Active CP version = <active SWC version>).
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby control processor (CP) does not support auto class-specific control (CS_CTL)
mode.
Recommended
Upgrade the standby CP firmware version to same level as active CP.
Action
Fabric OS Message Reference
53-1002749-01
5
SWCH-1025
851