Brocade Communications Systems StoreFabric SN6500B Reference page 205

Recommended
Execute the slotPowerOff and slotPowerOn commands or reseat the affected blade.
Action
BM-1004
Message
Blade firmware <Blade firmware> on slot <Slot> is not consistent with system
firmware <System firmware>. Auto-leveling blade firmware to match system firmware.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the policy of the specified blade is to auto-level the blade firmware to the system firmware.
This may be due to one of the following reasons:
•
•
Recommended
No action is required. The blade will automatically download the updated firmware.
Action
BM-1005
Message
Firmwaredownload timed-out for blade in slot <Slot>. Faulting blade.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the firmwareDownload command failed for the blade in the specified slot.
Recommended
Execute the slotPowerOff and slotPowerOn commands or reseat the affected blade.
Action
BM-1006
Message
Blade is not configured. Persistently disabling all ports for blade in slot <Slot
number>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the policy of the specified blade is set to persistently disable all ports the first time the blade
is detected. The message indicates either of the following:
•
•
Fabric OS Message Reference
53-1002749-01
Blade firmware was detected to be different from the control processor (CP) firmware due to a
firmware upgrade.
The blade was recently inserted and had a different version of the firmware loaded.
The blade was detected in this slot for the first time.
The blade was configured under a different mode.
5
BM-1004
183