Brocade Communications Systems StoreFabric SN6500B Reference page 145

AG-1006
Message
Access Gateway mode has been <message>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the Access Gateway mode has been enabled or disabled.
Recommended
Execute the ag --modeshow command to verify the current status of the Access Gateway mode.
Action
AG-1007
Message
FLOGI response not received for the N_Port <port number> connected to the fabric.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the N_Port connected to the fabric switch is not online. The specified N_Port has been
disabled.
Recommended
Check the connectivity between the Access Gateway N_Port and the fabric switch port.
Action
AG-1008
Message
Invalid Port Login (PLOGI) response from the fabric on the N_Port <port number>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the fabric switch management server did not accept the N_Port Login (PLOGI) request
sent by the Access Gateway.
Recommended
Check the configuration of the fabric switch connected to the Access Gateway.
Action
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
Fabric OS Message Reference
53-1002749-01
5
AG-1006
123