Brocade Communications Systems StoreFabric SN6500B Reference page 199

BL-1041
Message
Dynamic area mode is enabled on default switch, Faulting the blade w/ ID <Blade ID
of blade that has the mini SFP+ that does not support it> in slot <slot number> as
it does not support this mode.
Message Type
LOG
Severity
CRITICAL
Probable Cause
Indicates that the blade does not support dynamic area mode on the default switch.
Recommended
Turn off the dynamic area mode using the configure command.
Action
BL-1045
Message
mini SFP+ (SN: <mini SFP+ serial number>) is only supported in certain high port
count blades, not blade in slot <slot number of blade that has the mini SFP+> w/
ID <Blade ID of blade that has the mini SFP+ that does not support it>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that mini-SFP+ is supported only by a certain type of blade (FC8-64), but it can be inserted in
other blades.
Recommended
Replace the mini-SFP+ with an SFP or SFP+.
Action
BL-1046
Message
<Slot number of blade that has the SFP> error on SFP in Slot <Port number into
which the SFP is inserted>/Port <The type of error "checksum" or "data access" for
general problems accessing the i2c accessible data> (<A detailed error code>). Try
reseating or replacing it.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the checksum in an area on the small form-factor pluggable (SFP) transceiver does not
match with the computed value, or there is problem accessing the data.
Recommended
Reseat the SFP transceiver. If problem persists, replace the SFP transceiver.
Action
Fabric OS Message Reference
53-1002749-01
5
BL-1041
177