Brocade Communications Systems StoreFabric SN6500B Reference page 862

5
SULB-1038
SULB-1038
Message
Co-CPU has not booted up properly. Skip the firmwaredownload command on the
co-CPU.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
WARNING
Probable Cause
Indicates that the main CPU cannot access the co-CPU to update the firmware on the co-CPU or run any
other firmware download command on the co-CPU. If the firmwareDownload command is in progress, it
will continue without updating the co-CPU firmware.
Recommended
After the firmware download completes, reboot the CP manually to bring up the co-CPU and run the
Action firmwareDownload command again. If the problem persists, your switch service provider.
SULB-1039
Message
CP has completed relocating the internal firmware image.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
INFO
Probable Cause
Indicates that the firmware download process has completed normally on the control processor (CP).
Recommended
Run the firmwareShow command to verify the firmware versions.
Action
SULB-1040
Message
An error has occurred during relocation of the internal image on the CP.
Message Type
AUDIT | LOG
Class
FIRMWARE
Severity
WARNING
Probable Cause
Indicates that an error has occurred during the relocation of the internal image. The error may be caused
by an inconsistent internal firmware image. It may also be caused by an internal Ethernet failure.
Recommended
Run the firmwareShow command to verify the firmware versions. Run the firmwareDownload
Action command again if the firmware is not updated.
This will cause the internal image to be relocated again. If the problem persists, contact your switch
service provider.
840
Fabric OS Message Reference
53-1002749-01