Brocade Communications Systems StoreFabric SN6500B Reference page 387

FCR-1072
Message
Port <port number> is changed from FCR port to non FCR port.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the port is no longer an EX_Port or VEX_Port.
Recommended
No action is required.
Action
FCR-1073
Message
Switch with domain ID <domain ID> in fabric <fabric ID> has lower limit of LSAN
Zones supported.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that an older version switch in the backbone or edge that supports a different limit of logical
storage area network (LSAN) zones was detected.
Recommended
Use the fcrResourceShow command on all Fibre Channel Routers in the Meta-SAN to find lowest
Action supported LSAN zone limits. Ensure the total number of LSAN zones in the Meta-SAN are within the
lowest supported limit of LSAN zones.
FCR-1074
Message
HA sync lost as remote CP supports only <LSAN Count> LSAN Zones.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the remote control processor (CP) has older firmware, which supports a lower number of
logical storage area network (LSAN) zones. This is causing the loss of high availability (HA) sync.
Recommended
Keep the number of LSAN zones to the lower limit of the two CPs or upgrade the remote CP.
Action
Fabric OS Message Reference
53-1002749-01
5
FCR-1072
365