Brocade Communications Systems StoreFabric SN6500B Reference page 768

5
SEC-1321
SEC-1321
Message
Failed secure mode enable command. Reason: <Reason>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the security enable failed on the fabric because the switch has a conflicting configuration such
as fabric-wide consistency configuration or AD configuration.
Recommended
Verify the security event was planned. If the security event was planned, run the fddCfg --fabwideset
Action command or ad --clear command to clear the fabric wide consistency configuration or AD configuration
and retry the secModeEnable command.
SEC-1322
Message
Some DCC policy is too large, distribution cancelled.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates this fabric is not able to support a Device Connection Control (DCC) policy with more than 256
ports.
Recommended
Reconfigure any policy that includes more than 256 ports in its member list, and then save the policy
Action configuration changes.
SEC-1323
Message
Key(s) \"<Key Name>\" ignored during configdownload.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates the specified key is ignored during configuration download.
Recommended
Verify the event was planned. If the event was planned, no action is required. If the event was not
Action planned, take appropriate action as defined by your enterprise security policy.
746
Fabric OS Message Reference
53-1002749-01