Brocade Communications Systems StoreFabric SN6500B Reference page 852

5
SULB-1009
TABLE 7
Status message
"Remote CP is restoring its secondary partition."
"Firmware download has started."
"Firmware commit has started."
"Firmware download has completed successfully."
"Firmware commit has completed successfully."
"Firmware commit has started to restore the secondary partition."
"Firmware commit failed."
"The secondary partition has been restored successfully."
"Firmware is being downloaded to the blade. This step may take up to 10 minutes."
"Firmware download timed out."
"Reboot occurred during firmware download. Firmware commit will be started to
recover the blade."
"Blade rebooted during firmware commit. The operation will be restarted."
"Firmware has been downloaded successfully. Blade is rebooting with the new
firmware."
"Blade has rebooted successfully."
"New firmware failed to boot up. Run the
"Firmware commit has started on the blade. This may take up to 10 minutes."
"The
commit operation will start upon bootup."
"Switch is relocating the AP image."
"The AP image is relocated successfully."
"Switch reboots during relocating the AP image. The operation will be restarted."
"Blade failed to reboot with the original image. The
failed."
The following table lists additional
code provide more details on the reason for firmware download failure.
TABLE 8
Error message
"Image is up-to-date. No need to download the same version of firmware."
"Upgrade is inconsistent."
"OSRootPartition is inconsistent. For example: swap OSRootPartitions and reboot."
"Unable to access the required package list file. Check whether the switch is
supported by the requested firmware. Also check the
page for other possible failure reasons."
"The RPM package database is inconsistent. Contact your switch service provider for
recovery."
830
Status messages and status codes (Continued)
firmwareRestore
command is entered. System will reboot and a firmware
Error messages and error codes
firmwareDownload
command again."
firmwareRestore
error messages and error codes. The error
firmwareDownload
firmwareDownload
Status code
0x8e
0x8f
0x90
0x91
0x92
0x93
0x94
0x95
0xa0
0xa1
0xa2
0xa3
0xa4
0xa5
0xa6
0xa7
0xa8
0xa9
0xaa
0xab
command 0xac
Error code
0xF
0x10
0x11
0x12
help
0x13
Fabric OS Message Reference
53-1002749-01