Brocade Communications Systems StoreFabric SN6500B Reference page 923

Recommended
No action is required.
Action
ZONE-1046
Message
The Default Zone access mode is already set to All Access.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that the Default Zone access mode is already set to All Access.
Recommended
No action is required.
Action
ZONE-1048
Message
ZONE ACA is rejected on the standby.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the standby zoning component did not receive a syncdump command from the primary
side.
Recommended
Synchronize the standby control processor (CP) using the haSyncStart command.
Action
ZONE-1049
Message
ZONE AD-DefZone conflict detected while system initialization.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that there is an Admin Domain (AD) Default Zone conflict.
Recommended
Verify that the default zoning mode for AD0 is set to No Access using the defzone --show command. If
the default zoning mode is not set to No Access, execute the defzone --noaccess command and then
Action
execute the cfgsave command to commit the default zone mode change.
Fabric OS Message Reference
53-1002749-01
5
ZONE-1046
901