Brocade Communications Systems StoreFabric SN6500B Reference page 187

BL-1007
Message
blade #<blade number>: blade state is inconsistent with EM. bl_cflags 0x<blade
control flags>, slot_on <slot_on flag>, slot_off <slot_off flag>, faulty <faulty
flag>, status <blade status>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a failover occurred while a blade was initializing on the previously active control processor
(CP).
Recommended
No action is required. The blade is reinitialized. Because reinitializing a blade is a disruptive operation
Action and can stop I/O traffic, you may need to stop and restart the traffic during this process.
BL-1008
Message
Slot <slot number> control-plane failure. Expected value: 0x<value 1>, Actual:
0x<value 2>.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the blade has experienced a hardware failure or was removed without following the
recommended removal procedure.
Recommended
Make sure that the blade is seated correctly.
Action
If the blade is seated correctly, execute the diagPost command to make sure that Power-On Self-Test
(POST) is enabled; then power cycle the blade using the slotPowerOff and slotPowerOn commands or
have the blade's ejector switch cycled to run POST and verify that the blade does not have any hardware
problems.
If the message persists, replace the blade.
BL-1009
Message
Blade in slot <slot number> timed out initializing the chips.
Message Type
FFDC | LOG
Severity
CRITICAL
Probable Cause
Indicates that the blade has failed to initialize the application-specific integrated circuit (ASIC) chips.
Fabric OS Message Reference
53-1002749-01
5
BL-1007
165