Brocade Communications Systems StoreFabric SN6500B Reference page 339

FABR-1045
Message
Detected Base Switch conflict with remote (not neighbor) switch <Switchname>
(domain <Domain ID>), BS <Base Switch Mode>. No local E_Ports disabled.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the remote switch has a Base Switch attribute conflict with the local switch. But no ports
are disabled because the remote switch is not an adjacent to the local switch.
Recommended
Make sure that all the switches in the fabric have the same Base Switch attribute or disable VF mode for
Action the conflicting switch using the fosConfig command.
FABR-1046
Message
Detected Base Switch conflict with neighbor switch <Switchname> (domain <Domain
ID>), BS <Base Switch Mode>. E_Ports (<Number of E_Ports disabled>) connected to
the switch are disabled.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the remote switch has a Base Switch attribute conflict with the local switch. All the E_Ports
directly connected to the conflicting switch are disabled.
Recommended
Make sure that all the switches in the fabric have the same Base Switch attribute or upgrade the switch
Action firmware to a VF-capable firmware.
FABR-1047
Message
Area unavailable to assign to the port. Persistently disabling port <Port that is
being disabled>.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that there are no areas available to assign to the port during port creation.
Recommended
Move some ports out of the default switch to make areas available.
Action
Fabric OS Message Reference
53-1002749-01
5
FABR-1045
317