Brocade Communications Systems StoreFabric SN6500B Reference page 306

5
EM-1020
EM-1020
Message
Unit in <Slot number> with ID <FRU Id> is faulted, it's an FCoE blade and the
Ethernet switch service is not enabled. Please run <fosconfig --enable ethsw>.
Message Type
FFDC | LOG
Severity
ERROR
Probable Cause
Indicates that a blade inserted in the specified slot requires the Ethernet switch service, which is not
enabled. The blade is faulted.
Recommended
Execute the fosconfig --enable ethsw command to enable the Ethernet switch service. Note that this is
Action a disruptive command, which requires the system to be restarted. Otherwise, remove the blade.
EM-1028
Message
HIL Error: <function> failed to access history log for FRU: <FRU Id> (rc=<return
code>).
Message Type
FFDC | LOG
Severity
WARNING
Probable Cause
Indicates a problem accessing the data on the World Wide Name (WWN) card field-replaceable unit
(FRU) or the WWN card storage area on the main logic board.
The problems were encountered when the software attempted to write to the history log storage to record
an event for the specified FRU. The return code is for internal use only. This can indicate a significant
hardware problem.
The FRU ID value is composed of a FRU type string and an optional number to identify the unit, slot, or
port.
Recommended
If the problem persists, restart or power cycle the switch.
Action
If the problem still persists, replace the WWN card, or the switch (for non-bladed switches).
EM-1029
Message
<FRU Id>, a problem occurred accessing a device on the I2C bus (<error code>).
Operational status (<state of the FRU when the error occurred>) not changed,
access is being retried.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the Inter-Integrated Circuit (I2C) bus had problems and a timeout occurred.
284
Fabric OS Message Reference
53-1002749-01