Brocade Communications Systems StoreFabric SN6500B Reference page 736

5
SEC-1102
SEC-1102
Message
Fail to download <security data>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the switch failed to download a certificate, security database, or policies. This can happen
when the switch does not get enough resources to complete the operation, the fabric has not stabilized,
or the policy database is an invalid format.
Recommended
Wait for the fabric to become stable and then retry the operation. If the policy database is in an illegal
Action format (with configDownload command), correct the format and retry the operation.
SEC-1104
Message
Fail to get primary <Certificate or public key>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the switch failed to get either the primary certificate or a primary public key.
Recommended
Verify the primary switch has a valid certificate installed and retry the operation. If a valid certificate is not
Action installed, install a certificate by following the procedure specified in the Fabric OS Administrator's Guide.
SEC-1105
Message
Fail to disable secure mode on all switches.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates the switch failed to disable security in the fabric. This could happen if the switch cannot get the
required resources to complete the command, and sending to a remote domain fails or the remote
domain returns an error.
Recommended
Run the secFabricShow to verify that all switches in the fabric are in the ready state. Retry the
Action command when all switches are ready.
714
Fabric OS Message Reference
53-1002749-01