Brocade Communications Systems StoreFabric SN6500B Reference page 796

5
SNMP-1001
SNMP Messages
SNMP-1001
Message
SNMP service is not available <Reason>.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the Simple Network Management Protocol (SNMP) service could not be started because of
the specified reason. Therefore, you will not be able to query the switch through SNMP.
Recommended
Verify that the IP address for the Ethernet and Fibre Channel interface is set correctly. If the specified
Action reason is an initialization failure, restart the switch using the reboot command.
SNMP-1002
Message
SNMP <Error Details> initialization failed.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the initialization of the SNMP service failed and therefore you will not be able to query the
switch through SNMP.
Recommended
Restart or power cycle the switch. This will automatically initialize SNMP.
Action
SNMP-1003
Message
Distribution of Community Strings to Secure Fabric failed.
Message Type
LOG
Severity
ERROR
Probable Cause
Indicates that the changes in the SNMP community strings could not be propagated to other switches in
the secure fabric.
Recommended
Retry changing the SNMP community strings on the primary switch.
Action
774
Fabric OS Message Reference
53-1002749-01