Brocade Communications Systems StoreFabric SN6500B Reference page 363

FCPD Messages
FCPD-1001
Message
Probing failed on <error string>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that a Fibre Channel Protocol (FCP) switch probed devices on a loop port, and probing failed
on the L_Port, arbitrated loop physical address (AL_PA), or the F_Port. For ALPA, the valid range is 0x00
through 0xFF. The error variable can be either of the following:
•
•
This could happen due to some firmware issue with the device controller on the specified port.
Recommended
Contact the device vendor for any firmware-related issues. Also, consider upgrading the device firmware.
Action
FCPD-1002
Message
port <port number>, bad R_CTL for fcp probing: 0x<R_CTL value>.
Message Type
LOG
Severity
WARNING
Probable Cause
Indicates that the response frame received on the specified port for an inquiry request contains an invalid
value in the routing control field. This could happen due to some firmware issue with the device controller
on the specified port.
Recommended
Contact the device vendor for any firmware-related issues. Also, consider upgrading the device firmware.
Action
FCPD-1003
Message
Probing failed on <error string> which is possibly a private device which is not
supported in this port type.
Message Type
LOG
Severity
INFO
Probable Cause
Indicates that device probing has failed because private devices will not respond to the switch port login
(PLOGI) during probing.
Fabric OS Message Reference
53-1002749-01
L_Port ALPA
port_number
F_Port
port_number
alpa_number
5
FCPD-1001
341