Advertisement
track interface line-protocol
c e s
Configure object tracking on the line-protocol state of a Layer 2 interface.
Syntax
track object-id interface interface line-protocol
To return to the default setting, enter no track object-id.
Parameters
object-id
interface
Defaults
None
Command Modes
CONFIGURATION
Command
Version 8.4.1.0
History
Related
show track
Commands
track interface ip
routing
Usage
Use this command to create an object that tracks the line-protocol state of a Layer 2 interface by
Information
monitoring its operational status (UP or DOWN).
When the link-level status goes down, the tracked object status is considered to be DOWN; if the
link-level status is up, the tracked object status is considered to be UP.
Enter the ID number of the tracked object. Range: 1 to 65535.
Enter one of the following values:
For a 1-Gigabit Ethernet interface, enter gigabitethernet slot-number/
•
port-number.
•
For a Loopback interface, enter loopback number, where number is from 0 to
16383.
For a Port Channel interface, enter port-channe
•
are:
C-Series and S-Series: 1 to 128
E-Series: 1 to 32 for EtherScale; 1 to 255 for TeraScale; 1 to 512 for ExaScale.
•
For SONET interfaces, enter the sonet slot-number/port-number.
For a 10-Gigabit Ethernet interface, enter tengigabitethernet slot-number/
•
port-number
•
For a VLAN interface, enter vlan number, where number is from 1 to 4094.
Introduced
Display information about tracked objects, including configuration, current state, and
clients which track the object.
Configure object tracking on the routing status of an IPv4 Layer 3 interface.
l
number, where the valid values
Object Tracking | 997
Advertisement
