Advertisement
sflow enable (Global)
c e s
Syntax
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
sflow enable (Interface)
c e s
Syntax
Defaults
Command Modes
Command
History
1346
|
sFlow
As part of the sFlow-MIB, if the SNMP request originates from a configured collector, FTOS will
return the corresponding configured agent IP in MIB requests. FTOS checks to ensure that two entries
are not configured for the same collector IP with a different agent IP. Should that happen, FTOS
generates the following error:
%Error: Different agent-addr attempted for an existing collector
Enable sFlow globally.
sflow enable
To disable sFlow, use the no sflow enable command.
sFlow is disabled by default
CONFIGURATION
Version 8.2.1.0
Introduces on S-Series Stacking
Version 8.1.1.0
Introduced on E-Series ExaScale
Version 7.7.1.0
Introduced on S-Series
Version 7.6.1.0
Introduced on C-Series
Version 6.2.1.1
Introduced on E-Series
sFlow is disabled by default. In addition to this command, sFlow needs to be enable on individual
interfaces where sFlow sampling is desired.
sflow enable (Interface)
Enable sFlow on Interfaces.
sflow enable
To disable sFlow, use the no sflow enable command.
sFlow is disabled by default on all interfaces
INTERFACE
Version 8.2.1.0
Introduces on S-Series Stacking
Version 8.1.1.0
Introduced on E-Series ExaScale
Version 7.7.1.0
Introduced on S-Series
Version 7.6.1.0
Introduced on C-Series
Version 6.2.1.1
Introduced on E-Series
Enable sFlow on Interfaces.
Advertisement
