Advertisement
Usage
Syslog messages contain the IP address of the interface used to egress the router. By configuring the
Information
logging source-interface
configured.
Related
logging
Commands
logging synchronous
c e s
Synchronize unsolicited messages and FTOS output.
Syntax
logging synchronous [level level | all] [limit number-of-buffers]
To disable message synchronization, use the no logging synchronous [level level | all] [limit
number-of-buffers] command.
Parameters
all
level level
all
limit number-of-buffers
Defaults
Disabled. If enabled without level or number-of-buffers options specified, level = 2 and
number-of-buffers = 20 are the defaults.
Command Modes
LINE
Command
Version 7.6.1.0
History
Version 7.5.1.0
E-Series legacy command
Usage
When
Information
outputs. Only the messages with a severity at or below the set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system message
appears on that terminal line. Messages may continue to appear on other terminal lines.
Related
logging on
Commands
command, the Syslog packets contain the IP address of the interface
Enable the logging to another device.
Support added for S-Series
Support added for C-Series
logging synchronous
is enabled, unsolicited messages appear between software prompts and
Enables logging.
all
Enter the keyword
to ensure that all levels are printed asynchronously.
level
Enter the keyword
followed by a number as the severity level. A
high number indicates a low severity level and visa versa.
Range: 0 to 7.
Default: 2
all
Enter the keyword
to turn off all
limit
Enter the keyword
followed by the number of buffers to be queued
for the terminal after which new messages are dropped
Range: 20 to 300
Default: 20
SNMP and Syslog | 1379
Advertisement
