Advertisement
mib-binding
c e s
Syntax
Defaults
Command Modes
Command
History
Usage
Information
network area
c e s
Syntax
Parameters
Command Modes
Command
History
Usage
Information
1030
|
Open Shortest Path First (OSPFv2 and OSPFv3)
Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
mib-binding
To mib-binding on this OSPF process, enter no mib-binding.
None.
ROUTER OSPF
Version 7.8.1.0
This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the
first OSPF process will be used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB
responsibility.
Define which interfaces run OSPF and the OSPF area for those interfaces.
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id command.
ip-address
Specify a primary or secondary address in dotted decimal format. The primary address
is required before adding the secondary address.
mask
Enter a network mask in /prefix format. (/x)
area-id
Enter the OSPF area ID as either a decimal value or in a valid IP address.
Decimal value range: 0 to 65535
IP address format: dotted decimal format A.B.C.D.
Note: If the area ID is smaller than 65535, it will be converted to a decimal
value. For example, if you use an area ID of 0.0.0.1, it will be converted to 1.
ROUTER OSPF
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.1.1.1
To enable OSPF on an interface, the
the primary IP address of an interface.
Note:
An interface can be attached only to a single OSPF area.
Introduced to all platforms.
Introduced support for Multi-Process OSPF.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
network area
command must include, in its range of addresses,
Advertisement
