Advertisement
Example
Figure 41-1. ip pim join-filter Command Example
FTOS(conf)# ip access-list extended iptv-channels
FTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24
FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 any
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels in
FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels out
Related
ip access-list
Commands
extended
ip pim ingress-interface-map
c e s
When the Dell Force10 system is the RP, statically map potential incoming interfaces to (*,G) entries
to create a lossless multicast forwarding environment.
Syntax
ip pim ingress-interface-map std-access-list
Parameters
std-access-list
Defaults
None
Command Modes
INTERFACE
Command
Version 8.4.1.0
History
Example
FTOSFTOS(conf)# ip access-list standard map1
FTOS(config-std-nacl)# permit 224.0.0.1/24
FTOS(config-std-nacl)#exit
FTOS(conf)#int gig 1/1
FTOS(config-if-gi-1/1)# ip pim ingress-interface-map map1
ip pim neighbor-filter
c e s
Configure this feature to prevent a router from participating in protocol independent Multicast (PIM).
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list} command.
Parameters
access-list
Defaults
Defaults.
Command Modes
CONFIGURATION.
Command
Version 8.1.1.0
History
Version 7.8.1.0
Version 7.6.1.0
Configure an access list based on IP addresses or protocols.
Enter the name of an standard access list that permits the
Introduced
Enter the name of a standard access list. Maximum 16 characters.
Introduced on E-Series ExaScale
Introduced on C-Series and S-Series
Introduced on the E-Series
PIM-Sparse Mode (PIM-SM) | 1103
Advertisement
