Advertisement
Example
Figure 54-5. snmp ifmib ifalias long Command Example
!------command run on host connected to switch: --------------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected to Router2. This is a
port connected to
IF-MIB::ifAlias.134792448 = STRING:
!------command run on FTOS switch: --------------!
FTOS#snmp ifmib ifalias long
!------command run on server connected to switch: --------------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected to Router2. This is a
port connected to Router2. This is a port connected to Router2. This is a port
connected to Router2. This is a port connected to Router2.
IF-MIB::ifAlias.134792448 = STRING:
snmp-server community
c e s
Configure a new community string access for SNMPv1, v2, and v3.
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-access-list-name [ipv6
ipv6-access-list-name | access-list-name | security-name name] | security-name name
[ipv6 ipv6-access-list-name | access-list-name | security-name name] | access-list-name
[ipv6 ipv6-access-list-name | access-list-name | security-name name]]]
To remove access to a community, use the no snmp-server community community-string {ro |
rw} [security-name name [access-list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]] command.
Parameters
community-name
ro
rw
ipv6 access-list-name
security-name name
access-list-name
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
Version 7.6.1.0
History
Version 7.5.1.0
pre-Version.
6.2.1.1
Usage
The example below configures a community named public that is mapped to the security named
Information
guestuser with Read Only (ro) permissions.
Enter a text string (up to 20 characters long) to act as a password for SNMP.
Enter the keyword
Enter the keyword
(Optional) Enter the keyword
string up to 16 characters long).
(Optional) Enter the keyword
name as defined by the community MIB.
(Optional) Enter a standard IPv4 access list name (a string up to 16
characters long).
Support added for S-Series
Support added for C-Series
Introduced on E-Series
ro
to specify read-only permission.
rw
to specify read-write permission.
ipv6
followed by a an IPv6 ACL name (a
security-name
followed by the security
SNMP and Syslog | 1359
Advertisement
