Dell Force10 TeraScale E Series Reference Manual page 1198

Ftos command line, ftos 8.4.2.7

policy-map-input

Command Modes

policy-map-output

Quality of Service (QoS)

configurations in per-queue output QoS policies are ignored. Scheduling and queuing configura-

tions (WRED and Bandwidth) in the per-queue output QoS policy still apply to each queue.

policy-map-input

policy-map-output

Create an input policy map.

policy-map-input policy-map-name [layer2]

To remove an input policy map, use the no policy-map-input policy-map-name [layer2]

policy-map-name

Enter the name for the policy map in character format (32 characters maximum).

(OPTIONAL) Enter the keyword

Default: Layer 3

CONFIGURATION

Version 8.2.1.0

Policy name character limit increased from 16 to 32.

Version 7.6.1.0

Introduced on S-Series

Version 7.5.1.0

Introduced on C-Series

Version 7.4.1.0

Expanded to add support for Layer 2

pre-Version 6.1.1.1

Introduced on E-Series

Input policy map is used to classify incoming traffic to different flows using class-map, QoS policy, or

simply using incoming packets DSCP. This command enables policy-map-input configuration mode

(conf-policy-map-in).

service-queue

Assign a class map and QoS policy to different queues.

policy-aggregate

Allow an aggregate method of configuring per-port QoS via policy maps.

service-policy input

Apply an input policy map to the selected interface.

Create an output policy map.

policy-map-output policy-map-name

To remove a policy map, use the no policy-map-output policy-map-name command.

Create an input policy map

Create an output policy map (E-Series Only)

to specify a Layer 2 Class Map.