Advertisement
Parameters
process-id
interface
Command Modes
EXEC
EXEC Privilege
Command
Version 7.8.1.0
History
Version 7.6.1.0
Version 7.5.1.0
pre-Version 6.1.1.1
Usage
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
Information
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
(OPTIONAL) Enter the following keywords and slot/port or number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
the slot/port information.
•
For the null interface, enter the keyword
•
For loopback interfaces, enter the keyword
to 16383.
•
For a Port Channel interface, enter the keyword
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
•
For a SONET interface, enter the keyword
information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a VLAN, enter the keyword
to 4094.
process-id
Introduced
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
GigabitEthernet
null
followed by zero (0).
loopback
followed by a number from 0
port-channel
sonet
followed by the slot/port
TenGigabitEthernet
vlan
followed by the VLAN ID. The range is from 1
option, in support of Multi-Process OSPF.
Open Shortest Path First (OSPFv2 and OSPFv3) | 1053
followed by
followed by a
Advertisement
