Advertisement
ip pim rp-candidate
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
1106
|
PIM-Sparse Mode (PIM-SM)
Configure a PIM router to send out a Candidate-RP-Advertisement message to the Bootstrap (BS)
router or define group prefixes that are defined with the RP address to PIM BSR.
ip pim rp-candidate {interface [priority]
To return to the default value, enter no ip pim rp-candidate {interface [priority] command.
interface
priority
Not configured.
CONFIGURATION
Version 8.1.1.0
Version 7.8.1.0
pre-Version 6.1.1.1
Priority is stored at BSR router when receiving a Candidate-RP-Advertisement.
Enter the following keywords and slot/port or number information:
•
For a Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a Loopback interface, enter the keyword
number from 0 to 16383.
•
For a Port Channel interface, enter the keyword
followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
•
For a SONET interface, enter the keyword
port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
•
For a VLAN, enter the keyword
4094.
(OPTIONAL) Enter the priority used in Bootstrap election process.
Range: zero (0) to 255
Default: 192
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on E-Series
GigabitEthernet
loopback
followed by a
port-channel
sonet
followed by the slot/
vlan
followed by a number from 1 to
Advertisement
