Advertisement
Command
Version 7.8.1.0
History
Version 7.4.1.0
passive-interface
c e
Disable (suppress) sending routing updates on an interface.
Syntax
passive-interface interface
To enable sending routing updates on an interface, use the no passive-interface interface
command.
Parameters
interface
Defaults
Enabled, that is sending of routing updates are enabled by default
Command Modes
ROUTER OSPFv3
Command
Version 7.8.1.0
History
Version 7.4.1.0
Usage
By default, no interfaces are passive. Routing updates are sent to all interfaces on which the routing
Information
protocol is enabled.
If you disable the sending of routing updates on an interface, the particular address prefix will continue
to be advertised to other interfaces, and updates from other routers on that interface continue to be
received and processed.
OSPFv3 for IPv6 routing information is neither sent nor received through the specified router interface.
The specified interface address appears as a stub network in the OSPFv3 for IPv6 domain.
redistribute
c e
Redistribute into OSPFv3.
redistribute {bgp as number} {connected | static} [metric metric-value | metric-type
Syntax
type-value] [route-map map-name] [tag tag-value]
To disable redistribution, use the no redistribute {connected | static} command.
Added support for C-Series
Introduced
Enter the following keywords and slot/port or number information:
•
For a Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
followed by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to
512 for ExaScale.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
•
For a VLAN, enter the keyword
4094.
Added support for C-Series
Introduced
followed by the slot/port information.
vlan
followed by a number from 1 to
Open Shortest Path First (OSPFv2 and OSPFv3) | 1075
GigabitEthernet
port-channel
Advertisement
