Advertisement
The show ip ospf process-id statistics command displays the error packet count received on each
interface as:
•
•
•
•
•
•
•
•
Example
Figure 38-20. Command Example: show ip ospf process-id statistics
FTOS#show ip ospf 100 statistics
Interface GigabitEthernet 0/8
Intf-Down
Wrong-Len
Auth-Error
Version
SeqNo-Err
Related
clear ip ospf statistics
Commands
show ip ospf topology
c e s
Display routers in directly connected areas.
Syntax
show ip ospf process-id topology
Parameters
process-id
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
Version 7.8.1.0
History
The hello-timer remaining value for each interface
The wait-timer remaining value for each interface
The grace-timer remaining value for each interface
The packet count received and transmitted for each neighbor
Dead timer remaining value for each neighbor
Transmit timer remaining value for each neighbor
The LSU Q length and its highest mark for each neighbor
The LSR Q length and its highest mark for each neighbor
Hello-Timer 9, Wait-Timer 0, Grace-Timer 0
Error packets (Only for RX)
0
Non-Dr
0
Invld-Nbr
0
MD5-Error
0
AreaMisMatch
0
Unkown-Pkt
Neighbor ID 9.1.1.2
Hello
RX
59
TX
62
Dead-Timer
37, Transmit-Timer
LSU-Q-Len
LSR-Q-Len
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
Introduced support of Multi-Process OSPF.
0
Self-Org
0
Nbr-State
0
Cksum-Err
0
Conf-Issue
0
DDiscr
LSReq
LSUpd
3
1
1
2
1
0
0, LSU-Q-Wmark
0, LSR-Q-Wmark
Clear the packet statistics in all interfaces and neighbors
Open Shortest Path First (OSPFv2 and OSPFv3) | 1059
0
0
0
0
LSAck
1
0
0
0
1
Advertisement
