Advertisement
Example
Usage
Information
show config
c e s
Syntax
Command Modes
Command
History
Example
show ip ospf
c e s
Syntax
Parameters
Command Modes
Command
History
1036
|
Open Shortest Path First (OSPFv2 and OSPFv3)
Figure 38-4. Command Example: router ospf
FTOS(conf)#router ospf 2
FTOS(conf-router_ospf)#
You must have an IP address assigned to an interface to enter the ROUTER OSPF mode and configure
OSPF.
Once the OSPF process and the VRF are tied together, the OSPF Process ID cannot be used again in
the system.
Display the non-default values in the current OSPF configuration.
show config
ROUTER OSPF
Version 7.6.1.0
Introduced on S-Series
Version 7.5.1.0
Introduced on C-Series
pre-Version 6.1.1.1
Introduced on E-Series
Figure 38-5. Command Example: show config
FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
FTOS(conf-router_ospf)#
Display information on the OSPF process configured on the switch.
show ip ospf process-id [vrf vrf name]
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
vrf name
E-Series Only: Show only the OSPF information tied to the VRF process.
EXEC
EXEC Privilege
Version 7.9.1.0
Version 7.9.1.0
Version 7.8.1.0
Version 7.8.1.0
Introduced VRF
Introduced VRF
Introduced support of Multi-Process OSPF.
process-id
Introduced
option, in support of Multi-Process OSPF.
Advertisement
