Advertisement
Usage
FTOS 7.8.1.0 and later enhances the sFlow implementation for real time traffic analysis on the
Information
E-Series to provide extended gateway information in cases where the destination IP addresses are
learned by different routing protocols, and for cases where the destination is reachable over ECMP.
Related
sflow extended-gateway enable
Commands
sflow extended-router enable
show sflow
sflow polling-interval (Global)
c e s
Set the sFlow polling interval at a global level.
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
interval value
Defaults
20 seconds
Command Modes
CONFIGURATION
Command
Version 8.2.1.0
History
Version 8.1.1.0
Version 7.7.1.0
Version 7.6.1.0
Version 6.2.1.1
Usage
The polling interval for an interface is the maximum number of seconds between successive samples of
Information
counters to be sent to the collector. This command changes the global default counter polling (20 seconds)
interval. You can configure an interface to use a different polling interval.
Related
sflow polling-interval (Interface)
Commands
sflow polling-interval (Interface)
c e s
Set the sFlow polling interval at an interface (overrides the global-level setting.)
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Enable packing information on an extended gateway.
Enable packing information on a router.
Display the sFlow configuration
Enter the interval value in seconds.
Range: 15 to 86400 seconds
Default: 20 seconds
Introduces on S-Series Stacking
Introduced on E-Series ExaScale
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Set the polling interval for an interface
sFlow | 1349
Advertisement
