Advertisement
Command
History
Usage
Information
Related
Commands
ipv6 ospf priority
c e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
ipv6 router ospf
c e
Syntax
Parameters
Defaults
Command Modes
1074
|
Open Shortest Path First (OSPFv2 and OSPFv3)
Version 7.8.1.0
Added support for C-Series
Version 7.4.1.0
Introduced
The time interval between hello packets must be the same for routers in a network.
ipv6 ospf dead-interval
Set the priority of the interface to determine the Designated Router for the OSPFv3 network.
ipv6 ospf priority number
To return to the default value, use the no ipv6 ospf priority command.
number
1
INTERFACE
Version 7.8.1.0
Added support for C-Series
Version 7.4.1.0
Introduced
Setting a priority of 0 makes the router ineligible for election as a Designated Router or Backup
Designated Router.
Use this command for interfaces connected to multi-access networks, not point-to-point networks.
Enable OSPF for IPv6 router configuration.
ipv6 router ospf process-id
To exit OSPF for IPv6, enter no ipv6 router ospf process-id
process-id
No default behavior or values
CONFIGURATION
Set the time interval since the last hello-packet was received from a router.
Enter a number as the priority.
Range: 0 to 255.
Default: 1
Enter the process identification number.
Range: 1 to 65535
Advertisement
