Advertisement
Defaults
No default behavior or values
Command Modes
ROUTER RIP
Command
Version 7.8.1.0
History
Version 7.6.1.0
pre-7.7.1.0
Related
router rip
Commands
distance
c e s
Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower
weights ("administrative distance") are preferred.
Syntax
distance weight [ip-address mask [prefix-name]]
To return to the default values, use the no distance weight [ip-address mask] command.
Parameters
weight
ip-address
mask
prefix-name
Defaults
weight = 120
Command Modes
ROUTER RIP
Command
Version 7.8.1.0
History
Version 7.6.1.0
pre-Version 6.2.1.1
Related
default-metric
Commands
distribute-list in
c e s
Configure a filter for incoming routing updates.
Syntax
distribute-list prefix-list-name in [interface]
To delete the filter, use the no distribute-list prefix-list-name in command.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Enter ROUTER mode on the switch.
Enter a number from 1 to 255 for the
The default is 120.
(OPTIONAL) Enter the IP address, in dotted decimal format (A.B.C.D), of the host or
network to receive the new distance metric.
If you enter an IP address, you must also enter a mask for that IP address, in either dotted
decimal format or /prefix format (/x)
(OPTIONAL) Enter a configured prefix list name.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Assign one distance metric to all routes learned using the
weight (for prioritization)
.
redistribute
Router Information Protocol (RIP) | 1239
command.
Advertisement
