Advertisement
ip pim sparse-mode
c e s
Syntax
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
ip pim sparse-mode sg-expiry-timer
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
1108
|
PIM-Sparse Mode (PIM-SM)
Enable PIM sparse mode and IGMP on the interface.
ip pim sparse-mode
To disable PIM sparse mode and IGMP, enter no ip pim sparse-mode .
Disabled.
INTERFACE
Version 8.1.1.0
Version 7.8.1.0
C-Series supports a maximum of 31 PIM interfaces.
The interface must be enabled ( no shutdown command) and not have the switchport command
configured. Multicast must also be enabled globally (using the
is supported on the port-channel interface.
ip multicast-lag-hashing
Enable expiry timers globally for all sources, or for a specific set of (S,G) pairs defined by an access
list.
ip pim sparse-mode sg-expiry-timer seconds [access-list name]
To disable configured timers and return to default mode, enter no ip pim sparse-mode
sg-expiry-timer .
seconds
Enter the number of seconds the S, G entries will be retained.
Range 211-86400
access-list
(OPTIONAL) Enter the name of a previously configured Extended ACL to enable the
name
expiry time to specified S,G entries
Disabled. The default expiry timer (with no times configured) is 210 sec.
CONFIGURATION
Version 8.1.1.0
Version 7.8.1.0
Version 7.7.1.1
This command configures an expiration timer for all S.G entries, unless they are assigned to an
Extended ACL.
Introduced on E-Series ExaScale
Introduced on C-Series on port-channels and S-Series
Enable multicast globally.
Introduced on E-Series ExaScale
Introduced
Introduced
command). PIM
ip multicast-lag-hashing
Advertisement
