Advertisement
ip pim dense-mode
c e s
Syntax
Defaults
Command Modes
Command
History
Example
Usage
Information
Related
Commands
1096
|
PIM-Dense Mode (PIM-DM)
Enable PIM Dense-Mode (PIM-DM) Multicast capability for the specified interface.
ip pim dense-mode
To disable PIM-DM, use the no ip pim dense-mode command.
Disabled
INTERFACE
Version 8.4.2.1
Introduced on the C-Series and S-Series
Version 8.4.2.0
Introduced on the E-Series TeraScale
Version 8.1.1.0
Introduced on the E-Series ExaScale
Version 6.5.1.0
Introduced
Figure 40-1. ip pim dense-mode Command Example
FTOS#conf
FTOS(conf)# interface gigabitethernet 3/27
FTOS(gigabitethernet 3/27)# ip address 10.1.1.1 /24
FTOS(gigabitethernet 3/27)# no shut
FTOS(gigabitethernet 3/27)# ip pim dense-mode
FTOS#
Currently, the chassis operates in either PIM Dense-Mode or PIM Sparse-Mode. The mode
configuration for the first PIM enabled interface determines the mode for the entire chassis.
Subsequent configurations, on other interfaces, to enable PIM is only accepted if the mode is the same
as the original configuration mode. The chassis PIM mode can be changed if PIM-configuration from
all interfaces are removed prior to applying a new PIM mode configuration.
ip pim sparse-mode
show ip pim tib
Configure sparse-mode
Display PIM tree information.
Advertisement
