Advertisement
Command
History
Usage
Information
Related
Commands
network
c e s
Syntax
Parameter
Defaults
Command Modes
Command
History
Usage
Information
offset-list
c e s
Syntax
Parameters
1244
|
Router Information Protocol (RIP)
Version 7.8.1.0
Introduced on S-Series
Version 7.6.1.0
Introduced on C-Series
pre-Version 6.2.1.1
Introduced on E-Series
When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are
possible.
Use the
passive-interface
command in conjunction with the
specific interfaces are receiving and sending data.
passive-interface
Sets the interface to only listen to RIP broadcasts.
Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the
switch.
network ip-address
To disable RIP for a network, use the no network ip-address command.
ip-address
Specify an IP network address in dotted decimal format. You cannot specify a subnet.
No RIP network is configured.
ROUTER RIP
Version 7.8.1.0
Introduced on S-Series
Version 7.6.1.0
Introduced on C-Series
pre-Version 6.2.1.1
Introduced on E-Series
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address specified by the
Specify a number to add to the incoming or outgoing route metrics learned via RIP.
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in | out} offset [interface]
command.
prefix-list-name
Enter the name of an established Prefix list to determine which incoming routes will
be modified.
neighbor
command to ensure that only
network
command.
Advertisement
