Download Print this page

Dell Force10 TeraScale E Series Reference Manual page 1089

Ftos command line, ftos 8.4.2.7

Advertisement

redirect
c e s
Configure a rule for the redirect list.
Syntax
redirect {ip-address | sonet slot/port} {ip-protocol-number | protocol-type [bit]} {source mask
| any | host ip-address} {destination mask | any | host ip-address} [operator]
To remove this filter, use one of the following:
Parameters
ip-address
sonet slot/port
ip-protocol-number
protocol-type
bit
source
mask
any
host ip-address
destination
operator
Defaults
No default behavior or values
Command Modes
REDIRECT-LIST
Use the no seq sequence-number command syntax if you know the filter's sequence number.
Use the no redirect {ip-address | sonet slot/port} {ip-protocol-number [bit] | protocol-type}
{source mask | any | host ip-address} {destination mask | any | host ip-address}
[operator]
Enter the IP address of the forwarding router.
sonet
Enter the keyword
followed by the slot/port information.
Enter a number from 0 to 255 for the protocol identified in the IP protocol
header.
Enter one of the following keywords as the protocol type:
icmp
for Internet Control Message Protocol
ip
for Any Internet Protocol
tcp
for Transmission Control Protocol
udp
for User Datagram Protocol
(OPTIONAL) For TCP protocol type only, enter one or a combination of the
following TCP flags:
ack
= acknowledgement
fin
= finish (no more data from the user)
psh
= push function
rst
= reset the connection
syn
= synchronize sequence number
urg =
urgent field
Enter the IP address of the network or host from which the packets were sent.
Enter a network mask in /prefix format (/x).
any
Enter the keyword
to specify that all traffic is subject to the filter.
host
Enter the keyword
followed by the IP address to specify a host IP
address.
Enter the IP address of the network or host to which the packets are sent.
(OPTIONAL) For TCP and UDP parameters only. Enter one of the
following logical operand:
eq
= equal to
neq
= not equal to
gt
= greater than
lt
= less than
range
= inclusive range of ports (you must specify two ports for the
port
command parameter.)
Policy-based Routing (PBR) | 1089

Advertisement

loading