Advertisement
Example
Related
Commands
upgrade system stack-unit (S-Series stack member)
s
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
1408
|
S-Series Stacking Commands
Figure 56-6. stack-unit renumber Command Example
S50V_7.7#stack-unit 0 renumber 2
Renumbering master unit will reload the stack. Proceed to renumber [confirm yes/
no]:
reload
reset stack-unit
show system (S-Series)
Copy the boot image or FTOS from the management unit to one or more stack members.
upgrade {boot | system} stack-unit {all | 0-7}
boot
Enter this keyword to copy the boot image from the management unit to the
designated stack members.
system
Enter this keyword to copy the FTOS image from the management unit to the
designated stack members.
all
Enter this keyword to copy the designated image to all stack members.
0-7
Enter the unit ID of the stack member to which to copy the designated image.
No configuration or default values
EXEC
Version 7.7.1.0
Introduced on S-Series
You must reload FTOS after using the upgrade command.
reload
reset stack-unit
show system (S-Series)
show version
upgrade (S-Series management
unit)
Reboot FTOS.
Reset the designated S-Series stack member.
Display the current status of all stack members or a specific member.
Reboot FTOS.
Reset the designated S-Series stack member.
Display the current status of all stack members or a specific member.
Display the current FTOS version information on the system.
Upgrade the bootflash image or system image of the S-Series management
unit.
Advertisement
