Dell Force10 TeraScale E Series Reference Manual page 1384

ais-shut
e
Syntax
Defaults
Command Modes
alarm-report
e
Syntax
Parameters
Defaults
Command Modes
Usage
Information
1384 | SONET
• show interfaces
• sonet-port-recover detection-interval
• speed
Enable an alarm indication signal (AIS) when the SONET interface is shutdown.
ais-shut
To disable the AIS, enter no ais-shut.
Disabled.
INTERFACE
Specify which POS/SDH alarms to report to the remote SNMP server.
alarm-report {lais | lrdi | pais | plop | prdi | sd-ber | sf-ber | slof | slos}
To disable an alarm, use the no alarm-report {lais | lrdi | pais | plop | prdi | sd-ber | sf-ber | slof
| slos} command.
lais
Enter the keyword
lrdi
Enter the keyword
pais
Enter the keyword
plop
Enter the keyword
prdi
Enter the keyword
sd-ber
Enter the keyword
sf-ber
Enter the keyword
slof
Enter the keyword
slos
Enter the keyword
Disabled—no alarm reporting for all alarms
INTERFACE
Alarm reporting is available with this command. SNMP traps are available; however, syslogs are not
generated. To display active alarms and defects, use the
defines the alarms that can be enabled by this command. If enabled for reporting, the alarms will
generate reports on a trap receiver.
lais
to report line alarm indication signal.
lrdi
to report line remote defect indicator.
pais
to report path alarm indication signal.
plop
to report path loss of pointer.
prdi
to report the path remote defect indication.
sd-ber
to report signal degradation BER errors.
sf-ber
to report signal failure BER errors.
slof
to report section loss of frame.
slos
to report section loss of signal.
show controllers command. The table below