Advertisement
protocol spanning-tree rstp
c e s
Syntax
Defaults
Command Modes
Command
History
Example
Usage
Information
Related
Commands
show config
c e s
Syntax
Command Modes
Command
History
Example
1270
|
Rapid Spanning Tree Protocol (RSTP)
Enter the RSTP mode to configure RSTP.
protocol spanning-tree rstp
To exit the RSTP mode, enter exit
Not configured
CONFIGURATION RSTP (conf-rstp)
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
Version 6.2.1.1
Introduced for E-Series
Figure 50-2. protocol spanning-tree rstp Command
FTOS(conf)#protocol spanning-tree rstp
FTOS(config-rstp)##no disable
RSTP is not enabled when you enter the RSTP mode. To enable RSTP globally on the system, enter
description
from the RSTP mode.
description
Disable RSTP globally on the system
View the current configuration for the mode. Only non-default values are displayed.
show config
CONFIGURATION RSTP (conf-rstp)
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
Version 6.2.1.1
Introduced for E-Series
Figure 50-3. show config Command for the RSTP Mode
FTOS(conf-rstp)#show config
!
protocol spanning-tree rstp
no disable
bridge-priority 16384
.
no
Advertisement
