Advertisement
ipv6 pim sparse-mode
e
Syntax
Defaults
Command Modes
Command
History
Usage
Information
ipv6 pim spt-threshold
e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
1126
|
PIM-Sparse Mode (PIM-SM)
Enable IPv6 PIM sparse mode on the interface.
ipv6 pim sparse-mode
To disable IPv6 PIM sparse mode, enter no ipv6 pim sparse-mode.
Disabled
INTERFACE
Version 7.4.1.0
The interface must be enabled (no shutdown command) and not have the switchport command
configured. Multicast must also be enabled globally. PIM is supported on the port-channel interface.
Specifies when a PIM leaf router should join the shortest path tree.
ipv6 pim spt-threshold {kbps | infinity}
To return to the default value, enter no ipv6 pim spt-threshold.
kbps
Enter a traffic rate in kilobytes per second.
Range: 0 to 4294967 kbps
Default: 10 kbps
infinity
Enter the keyword
never join shortest path tree (SPT).
10 kbps
CONFIGURATION
Version 7.4.1.0
Introduced
PIM leaf routers join the shortest path tree immediately after the first packet arrives from a new source.
Introduced
infinity
to have all sources for the specified group use the shared tree and
Advertisement
