Advertisement
Defaults
Command Modes
Command
History
Usage
Information
ip pim join-filter
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
1102
|
PIM-Sparse Mode (PIM-SM)
restart-time
stale-entry-time
as above
CONFIGURATION
Version 8.2.1.0
Introduced on E-Series ExaScale. Added the
Version 7.6.1.0
Introduced on E-Series
When an NSF-capable router comes up, it announces the graceful restart capability and restart duration
as a Hello option. The receiving router notes the Hello option. Routers not NSF capable will discard
the unknown Hello option and adjacency is not affected.
When an NSF-capable router goes down, neighboring PIM speaker preserves the states and continues
the forwarding of multicast traffic while the neighbor router restarts.
Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This
command prevents the PIM SM router from creating state based on multicast source and/or group.
ip pim join-filter ext-access-list { in | out }
Remove the access list using the command no ip pim join-filter ext-access-list { in | out }
ext-access-list
Enter the name of an extended access list.
in
Enter this keyword to apply the access list to inbound traffic.
out
Enter this keyword to apply the access list to outbound traffic.
None
INTERFACE
Version 8.1.1.0
Introduced on E-Series ExaScale
Version 7.8.1.0
Introduced on C-Series on port-channels and S-Series
Version 7.7.1.0
Introduced on E-Series.
(OPTIONAL) Enter the keyword
seconds estimated for the PIM speaker to restart.
Range: 30 to 300 seconds
Default: 180 seconds
(OPTIONAL) Enter the keyword
seconds for which entries are kept alive after restart.
Range: 30 to 300 seconds
Default: 60 seconds
restart-time
followed by the number of
stale-entry-time
followed by the number of
ipv6
option for E-Series.
Advertisement
