Advertisement
Command
History
Usage
Information
Related
Commands
Queue-Level Debugging
clear queue statistics egress
e
Syntax
Parameters
Defaults
Command Modes
Command
History
1224
|
Quality of Service (QoS)
pre-Version 6.1.1.1
Introduced on E-Series
Use the default pre-defined profiles or configure your own profile. You can not delete the pre-defined
profiles or their default values. This command enables the WRED configuration mode—(conf-wred).
threshold
Specify the minimum and maximum threshold values of the WRED profile
Queue-Level Debugging is an E-Series-only feature, as indicated by the
below each command heading.
The following queuing statistics are available on both the EtherScale and TeraScale versions of
E-Series systems.
•
clear queue statistics egress
•
clear queue statistics ingress
•
show queue statistics egress
•
show queue statistics ingress
Clear egress queue statistics.
clear queue statistics egress [unicast | multicast] [Interface]
unicast | multicast
Interface
No default behavior or values
EXEC
EXEC Privilege
Version 6.2.1.1
Introduced
(OPTIONAL) Enter the keyword
unicast
statistics. Enter the keyword
Default: Both Unicast and Multicast queue statistics are cleared.
(OPTIONAL) Enter one of the following interfaces to display the interface
specific queue statistics.
•
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
•
For a SONET interface, enter the keyword
information.
•
Fast Ethernet is not supported
e
character that appears
multicast
to clear only Multicast queue
to clear only Unicast queue statistics.
GigabitEthernet
sonet
followed by the slot/port
Advertisement
