Advertisement
Parameters
Defaults
Command Modes
Command
History
ipv6 pim dr-priority
e
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
1122
|
PIM-Sparse Mode (PIM-SM)
interface
Enter the following keywords and slot/port or number information:
•
•
•
•
•
hash-mask-length
(OPTIONAL) Enter the hash mask length for RP selection.
Range: 0 to 128
Default: 126
priority
(OPTIONAL) Enter the priority value for Bootstrap election process.
Range: 0 to 255
Default: 0
As above
CONFIGURATION
Version 7.4.1.0
Introduced
Change the Designated Router (DR) priority for the IPv6 interface.
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
priority-value
Enter a number. Preference is given to larger/higher number.
Range: 0 to 4294967294
Default: 1
1
INTERFACE
Version 7.4.1.0
Introduced
The router with the largest value assigned to an interface becomes the Designated Router. If two
interfaces contain the same DR priority value, the interface with the largest interface IP address
becomes the Designated Router.
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
For a Loopback interface, enter the keyword
number from 0 to 16383.
For a Port Channel interface, enter the keyword
number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
For a VLAN, enter the keyword
GigabitEthernet
loopback
followed by a
port-channel
vlan
followed by a number from 1 to 4094.
followed by a
Advertisement
