Advertisement
offset
interface
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
Version 7.8.1.0
History
Version 7.6.1.0
pre-Version 6.2.1.1
Usage
When the offset metric is applied to an interface, that value takes precedence over an offset value that
Information
is not extended to an interface.
Related
ip prefix-list
Commands
output-delay
c e s
Set the interpacket delay of successive packets to the same neighbor.
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, enter no output-delay.
Parameters
delay
Default
Not configured.
Command Modes
ROUTER RIP
Command
Version 7.8.1.0
History
Version 7.6.1.0
pre-Version 6.2.1.1
Enter a number from zero (0) to 16 to be applied to the incoming route metric
matching the access list specified.
If you set an offset value to zero (0), no action is taken.
(OPTIONAL) Enter the following keywords and slot/port or number information:
•
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a Port Channel interface, enter the keyword
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
•
For a SONET interface, enter the keyword
information.
•
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
•
For a VLAN, enter the keyword
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
Enter the PREFIX-LIST mode and configure a prefix list.
Specify a number of milliseconds as the delay interval.
Range: 8 to 50.
Introduced on S-Series
Introduced on C-Series
Introduced on E-Series
GigabitEthernet
port-channel
sonet
followed by the slot/port
TenGigabitEthernet
vlan
followed by a number from 1 to 4094.
Router Information Protocol (RIP) | 1245
followed by a
Advertisement
