Advertisement
Defaults
Command Modes
Command
History
Usage
Information
Example
Related
Commands
snmp-server host
c e s
Syntax
Parameters
1364
|
SNMP and Syslog
As defined above
CONFIGURATION
Version 7.6.1.0
Support added for S-Series
Version 7.5.1.0
Support added for C-Series
E-Series legacy command
The following example specifies the group named harig as a version 3 user requiring both
authentication and encryption and read access limited to the read named rview.
Note:
For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP; TCP, ICMP rules are
not valid for SNMP. In IPv6 ACLs port rules are not valid for SNMP.
Figure 54-8. snmp-server group Command Example
FTOS#conf
FTOS(conf)# snmp-server group harig 3 priv read rview
FTOS#
Note:
The number of configurable groups is limited to 16 groups.
show snmp group
show running-config snmp
Configure the recipient of an SNMP trap operation.
snmp-server host ip-address | ipv6-address [traps | informs] [version 1 | 2c | 3] [auth | no
auth | priv] [community-string] [udp-port port-number] [notification-type]
To remove the SNMP host, use the no snmp-server host ip-address [traps | informs] [version
1 | 2c | 3] [auth | noauth | priv] [community-string] [udp-port number] [notification-type]
command.
ip-address
ipv6-address
traps
informs
Display the group name, security model, view status, and storage type of
each group.
Display the SNMP running configuration
host
Enter the keyword
followed by the IP address of the host (configurable
hosts is limited to 16).
host
Enter the keyword
followed by the IPv6 address of the host in the
x:x:x:x::x
format.
::
The
notation specifies successive hexadecimal fields of zero
(OPTIONAL) Enter the keyword
specified host.
Default: traps
(OPTIONAL) Enter the keyword
specified host.
Default: traps
traps
to send trap notifications to the
informs
to send inform notifications to the
Advertisement
