Advertisement
ip igmp snooping last-member-query-interval
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
ip igmp snooping mrouter
c e s
Syntax
Parameters
Defaults
Command Modes
Command
History
558
|
Internet Group Management Protocol (IGMP)
The last member query interval is the "maximum response time" inserted into Group-Specific queries
sent in response to Group-Leave messages. This interval is also the interval between successive
Group-Specific Query messages. Use this command to change the last member query interval.
ip igmp snooping last-member-query-interval milliseconds
To return to the default value, enter no ip igmp snooping last-member-query-interval.
milliseconds
Enter the interval in milliseconds.
Default: 1000 milliseconds
Range: 100 to 65535
1000 milliseconds
INTERFACE VLAN
Version 7.6.1.0
Introduced on S-Series
Version 7.5.1.0
Introduced on C-Series
E-Series legacy command
Statically configure a VLAN member port as a multicast router interface.
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping mrouter interface
interface command.
interface
Enter the following keywords and slot/port or number information:
interface
•
•
•
•
Not configured
INTERFACE VLAN—(conf-if-vl-n)
Version 7.6.1.0
Introduced on S-Series
Version 7.5.1.0
Introduced on C-Series
E-Series legacy command
For an 100/1000 Ethernet interface, enter the keyword
followed by the slot/port information.
For a 1-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
For a Port Channel interface, enter the keyword
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
GigabitEthernet
GigabitEthernet
TenGigabitEthernet
port-channel
followed by a
Advertisement
