Advertisement
Remote Monitoring (RMON)
Overview
FTOS RMON is implemented on all Dell Force10 switching platforms (C-Series, E-Series, and
S-Series), as indicated by the characters that appear below each command heading:
•
•
•
FTOS RMON is based on IEEE standards, providing both 32-bit and 64-bit monitoring, and long-term
statistics collection. FTOS RMON supports the following RMON groups, as defined in RFC-2819,
RFC-3273, and RFC-3434:
•
•
•
•
•
•
•
•
•
FTOS RMON does not support the following statistics:
•
•
•
Commands
The FTOS Remote Network Monitoring RMON commands are:
•
•
•
•
c
C-Series:
e
E-Series:
s
S-Series:
Ethernet Statistics Table
Ethernet Statistics High-Capacity Table
Ethernet History Control Table
Ethernet History Table
Ethernet History High-Capacity Table
Alarm Table
High-Capacity Alarm Table (64bits)
Event Table
Log Table
etherStatsCollisions
etherHistoryCollisions
etherHistoryUtilization
Note:
Only SNMP GET/GETNEXT access is supported. Configure RMON using the
RMON commands. Collected data is lost during a chassis reboot.
rmon alarm
rmon collection history
rmon collection statistics
rmon event
RFC-2819
RFC-3273, 64bits
RFC-2819
RFC-2819
RFC-3273, 64bits
RFC-2819
RFC-3434, 64bits
RFC-2819
RFC-2819
Remote Monitoring (RMON) | 1253
49
Advertisement
