Advertisement
Parameters
policy-map-name
Defaults
No default behavior or values
Command Modes
CONFIGURATION
Command
Version 8.2.1.0
History
Version 7.6.1.0
pre-Version 6.1.1.1
Usage
Output policy map is used to assign traffic to different flows using QoS policy. This command enables
Information
the policy-map-output configuration mode (conf-policy-map-out).
Related
service-queue
Commands
policy-aggregate
service-policy output
qos-policy-input
c e s
Create a QoS input policy on the router.
qos-policy-input qos-policy-name [layer2]
Syntax
To remove an existing input QoS policy from the router, use no qos-policy-input qos-policy-name
[layer2] command.
Parameters
qos-policy-name
layer2
Defaults
Layer 3
Command Modes
CONFIGURATION
Command
Version 8.2.1.0
History
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Usage
Use this command to specify the name of the input QoS policy. Once input policy is specified,
Information
rate-police can be defined. This command enables the qos-policy-input configuration mode—
(conf-qos-policy-in).
Enter the name for the policy map in character format (16 characters
maximum).
Policy name character limit increased from 16 to 32.
Introduced on C-Series and S-Series
Introduced on E-Series
Assign a class map and QoS policy to different queues.
Allow an aggregate method of configuring per-port QoS via policy maps.
Apply an output policy map to the selected interface.
Enter your input QoS policy name in character format (32 character
maximum).
(OPTIONAL) Enter the keyword
Default: Layer 3
Policy name character limit increased from 16 to 32.
Introduced on S-Series
Introduced on C-Series
E-Series Only: Expanded to add support for Layer 2
layer2
to specify a Layer 2 Class Map.
Quality of Service (QoS) | 1199
Advertisement
