Advertisement
Usage
The
Information
places traffic marked with a priority in the correct queue and processes that traffic according to its
queue.
When you set the priority for a Port Channel, the physical interfaces assigned to the Port Channel are
configured with the same value. You cannot assign a
in a Port Channel.
rate limit
e
Limit the outgoing traffic rate on the selected interface.
Syntax
rate limit [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]] [vlan vlan-id]
Parameters
kbps
committed-rate
burst-KB
peak peak-rate
vlan vlan-id
Defaults
Granularity for committed-rate and peak-rate is Mbps unless the kbps option is used.
Command Modes
INTERFACE
Command
Version 8.2.1.0
History
Version 7.7.1.0
Version 7.5.1.0
pre-Version 6.1.1.1
Usage
Information
On one interface, you can configure the
configure the
can configure six
dot1p-priority
command changes the priority of incoming traffic on the interface. The system
Enter this keyword to specify the rate limit in Kilobits per second (Kbps). On the
E-Series, Dell Force10 recommends using a value greater than or equal to 512 as
lower values does not yield accurate results.The default granularity is Megabits per
second (Mbps).
Range: 0 to 10000000
Enter the bandwidth in Mbps
Range: 0 to 10000
(OPTIONAL) Enter the burst size in KB.
Range: 16 to 200000
Default: 50
(OPTIONAL) Enter the keyword
rate in Mbps.
Range: 0 to 10000
(OPTIONAL) Enter the keyword
those specific VLANs.
Range: 1 to 4094
kbps
Added
Removed from C-Series
Introduced on C-Series
Introduced on E-Series
Note:
Per Port rate limit and rate police is supported for Layer 2 tagged and untagged
switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate police is supported on
only tagged ports with Layer 2 switched traffic.
rate limit
or the
rate police
rate limit
commands specifying different VLANS.
dot1p-priority
peak
vlan
option on E-Series.
rate limit
or
rate police
command for the interface. For each physical interface, you
command to individual interfaces
followed by a number to specify the peak
followed by a VLAN ID to limit traffic to
command for a VLAN or you can
Quality of Service (QoS) | 1181
Advertisement
